American Standard 2461002.011 Guide d'installation télécharger pdf (Page 2)

TYPICAL RECESS INSTALLATION

610 mm

(24)

305mm

(12)

441mm

(17-3/8)

1527mm

(60-1/8)

229 X 305mm

(9 X 12) FLOOR

CUTOUT

813mm

(32)

TUB WI

DTH

791033-100 Rev. M (2)

FRAMING AND INSTALLATION

Bath may only be installed above the ﬂoor line in a recess type installation, as shown in recess installation diagram.

Locate studs as required. Insure rough dimensions are proper, plumb and square.

For whirlpools, provision must be made in all installations for an access opening for servicing pump and controls.

The following procedure must be used for all installations: leveling support stringer should be as indicated.

The bath is supported from the apron and the rear tiling ﬂange. No support under the sump is necessary.

Position bathtub/whirlpool within the recess, check level, front to back, side to side, and shim as necessary.

Also check drain clearance hole in the subﬂoor.

To secure the tub to wood studs use rooﬁng nails immediately above the ﬂange of the tub.

To secure the tub to steel studs use drywall screws and ﬂatwashers.

Caution: take extra care when driving nails or screws to avoid damaging the tub.

The tile or similar ﬁnished ﬂoor will be butted against the bottom of the tub apron, also holding the tub in place.

SUGGESTED WHIRLPOOL/BATH INSTALLATION METHOD

SECURE THE BATH TO THE STUDS

AS SHOWN FOR WOOD OR STEEL STUD

CONSTRUCTION.

STUD

SHIM

DRY WALL

TILE

SEALANT

TUB

ROOFING NAIL

51 x 102mm (2 x 4) WOOD

STRINGER FULL LENGTH

51 x 102mm (2 x 4) WOOD

STRINGER FULL LENGTH

STEEL

STUD

SHIM

DRY WALL

WASHER

TILE

SEALANT

TUB

4" (102mm)

DRYWALL

SCREW

WOOD STUDS

STEEL STUDS

WHIRLPOOL ONLY:

UNLESS AN ACCESS OPENING OF AT LEAST

12" X 24" (305 X 610MM) IS PROVIDED,

WARRANTY SERVICE WILL NOT BE PERFORMED.

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

American Standard 2461002.011 Guide d'installation Page 2

Commentaires sur ces manuels