American Standard 2100 Manuel d'utilisateur télécharger pdf

RECOMMENDED TOOLS AND MATERIALS

Putty Knife Regular Screwdriver Adjustable Wrench Sealant Tape Measure

Hacksaw Wax Ring/Gasket Flexible Supply Tube Closet Bolts Carpenters Level

1 REMOVE OLD TOILET

a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.

b. Disconnect and remove supply line. NOTE:

If replacing valve, first shut off main water supply!

c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.

d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.

NOTE:

Mounting surface must be clean and level before new toilet is installed!

INSTALL CLOSET BOLTS

Install closet bolts in flange channel, turn 90

, and slide

into place 6" (152 mm) apart and parallel to wall.

SAVE FOR FUTURE USE

CLOSET FLANGE

CLOSET BOLTS

730481-100 Rev. C

Saniwares

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

Product names listed herein are trademarks of American Standard Inc.

NOTE:

Pictures may not exactly define contour of china and components.

CADET 1.6 GPF ONE-PIECE TOILET

2099/2100

ROUGHING-IN DIMENSIONS:

NOTE:

Distance from wall to closet flange centerline must be as listed below:

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product

is installed properly, please read these instructions carefully before you begin. (Certain installations may require

professional help.) Also be sure your installation conforms to local codes.

INSTALLATION

INSTRUCTIONS

INSTALL WAX SEAL

Invert toilet on floor (cushion to prevent damage), and

install wax ring evenly around waste flange (horn), with

tapered end of ring facing toilet. Apply a thin bead of

sealant around toilet base.

POSITION TOILET ON FLANGE

a. Unplug floor waste opening and install toilet on closet flange so bolts project

through mounting holes.

b. Loosely install retainer washers and nuts. Side of washers marked "THIS

SIDE UP"

must

face up!

WAX RING

SEALANT

WASHER

NUT

FLANGE

BOLT

762mm

(30)

679mm

(26-3/4)

397mm

(15-5/8)

711mm

(28)

FINISHED WALL

305mm

(12)

C/L OF OUTLET

FINISHED

FLOOR

140mm

(5-1/2)

SUPPLY AS

REQ'D

FINISHED

FLOOR

79mm

(3-1/8)

Model 2100 - Elongated w/Seat, Model 2099 - Round Front, Seat Not Included

1 2 3 4

Résumé du contenu

Page 1 - INSTRUCTIONS

RECOMMENDED TOOLS AND MATERIALSPutty Knife Regular Screwdriver Adjustable Wrench Sealant Tape MeasureHacksaw Wax Ring/Gasket Flexible Supply Tube Clos

Page 2 - PLASTIC SUPPLY LINE

730481-100 Rev. C 67INSTALL TOILETa. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Altern

Page 3 - CADET REPAIR PARTS LIST

730481-100 Rev. C 9 10 ADJUSTMENTS a. Adjust water level. Water level should be adjusted to level indicated on tank by adjusting float cup.Se

Page 4 - San Juan Capistrano, CA 92675

730481-100 Rev. C 12AMERICAN-STANDARD ONE-YEAR LIMITED WARRANTYIf inspection of this American-Standard plumbing product, within one year after its ini